Distance - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Version 8.3.7.0

Version 7.8.1.0

Version 7.6.1.0

distance

Assign a weight (for prioritization) to all routes in the RIP routing table or to a specific route. Lower

weights ("administrative distance") are preferred.

distance weight [ip-address mask [prefix-name]]

To return to the default values, use the no distance weight [ip-address

mask] command.

Routing Information Protocol (RIP)

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.

— enters ROUTER mode on the switch.

Enter a number from 1 to 255 for the weight (for

prioritization). The default is 120.

(OPTIONAL) Enter the IP address, in dotted decimal format

(A.B.C.D), of the host or network to receive the new distance

If you enter an IP address, also enter a mask for that IP

address, in either dotted decimal format or /prefix format

(OPTIONAL) Enter a configured prefix list name.