Radius-Server Deadtime - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

Not configured.

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Version 8.5.1.0

Version 8.3.7.0

Version 7.6.1.0

Version 7.5.1.0

radius-server deadtime

Configure a time interval during which non-responsive RADIUS servers to authentication requests are

radius-server deadtime seconds

To disable this function or return to the default value, use the no radius-server

deadtime command.

For Loopback interfaces, enter the keyword loopback

then a number from zero (0) to 16838.

For the Null interface, enter the keywords null 0.

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

For a ten-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Added support for 4-port 40G line cards on ExaScale.

Introduced on the S4810.

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.