Protocol Spanning-Tree Pvst - Dell S4810 Reference Manual

protocol spanning-tree pvst

To enable PVST+ on a device, enter the PVST+ mode.
S4810
Syntax
protocol spanning-tree pvst
To disable PVST+, use the disable command.
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
Version 8.3.1.0
Example
Dell#conf
Dell(conf)#protocol spanning-tree pvst
Dell(conf-pvst)#no disable
Dell(conf-pvst)#vlan 2 bridge-priority 4096
Dell(conf-pvst)#vlan 3 bridge-priority 16384
Dell(conf-pvst)#
Dell(conf-pvst)#show config
!
protocol spanning-tree pvst
Dell#
Usage After you enable PVST+, the device runs an STP instance for each VLAN it supports.
Information
Related
disable
Commands
show spanning-tree pvst
1314
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced.
no disable
vlan 2 bridge-priority 4096
vlan 3 bridge-priority 16384
— disables PVST+.
— displays the PVST+ configuration.
Per-VLAN Spanning Tree Plus (PVST+)