Sflow Extended-Switch Enable - Dell S4810 Reference Manual

Defaults Disabled.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.7.1.0
Version 7.6.1.0
Version 6.2.1.1
Usage When you enable sFlow on an interface, flow sampling is done on any traffic going
Information out of the interface.
Related sflow enable (Global)
Commands

sflow extended-switch enable

Enable packing information on a switch only.
S4810
Syntax
sflow extended-switch enable
To disable packing information, use the no sflow extended-switch [enable]
command.
Parameters
enable
1546
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on S-Series Stacking.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
NOTE: After a physical port is a member of a LAG, it inherits the sFlow
configuration from the LAG port.
— turns sFlow on globally.
Enter the keyword enable to enable global extended
information.
sFlow