Qos-Policy-Output - Dell S4810 Reference Manual

Defaults Layer 3
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Usage
Use this command to specify the name of the input QoS policy. Once input policy
Information
is specified, rate-police can be defined. This command enables the qos-policy-
input configuration mode— (conf-qos-policy-in).
When changing a Service-Queue configuration in a QoS policy map, all QoS rules
are deleted and re-added automatically to ensure that the order of the rules is
maintained. As a result, the Matched Packets value shown in the show qos
statistics command is reset.
Related rate police
Commands

qos-policy-output

Create a QoS output policy.
S4810
Syntax
qos-policy-output qos-policy-name
To remove an existing output QoS policy, use the no qos-policy-output qos-
policy-name command.
Parameters
qos-policy-
name
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
Quality of Service (QoS)
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
— incoming traffic policing function.
Enter your output QoS policy name in character format (32
characters maximum).
1349