Multicast; Ipv4 Multicast Commands; Clear Ip Mroute - Dell S4810 Reference Manual

Multicast

The multicast commands are supported by Dell Networking operating system (OS) on all S4810 platform.
This chapter contains the following sections:
•

IPv4 Multicast Commands

IPv4 Multicast Commands
The following section contains the IPv4 multicast commands.

clear ip mroute

Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent
multicast (PIM) tree information base, use the clear ip pim tib command.
S4810
Syntax
clear ip mroute {group-address [source-address] | * | snooping}
Parameters
group-address
[source-
address]
*
snooping
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2.
(0.0)
Version 9.0.2.0
Version
8.3.19.0
Multicast
Enter the multicast group address and source address (if
desired), in dotted decimal format, to clear information on a
specific group.
Enter * to clear all multicast routes.
Enter the keyword snooping to delete multicast snooping
route table entries.
Added support for keyword snooping on the Z9000, S4810,
and S4820T.
Introduced on the S6000.
Introduced on the S4820T.
38
1133