Fefd Disable - Dell S4810 Reference Manual

Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version
8.3.12.0
Usage When you enter no fefd for an interface and fefd-global, FEFD is enabled on
Information the interface because the no fefd command is not retained in the configuration
file. To keep the interface FEFD disabled when the global configuration changes,
use the fefd reset command.
Related
•
Commands
•
•

fefd disable

Disable FEFD on an interface only. This command overrides the fefd reset command for the interface.
S4810
Syntax
fefd disable
To re-enable FEFD on an interface, use the no fefd disable command.
Defaults Not configured.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Legacy E-
Series
command.
Usage When you enter no fefd for an interface and fefd-global, FEFD is enabled on the
Information
interface because the no fefd command is not retained in the configuration file.
To keep the interface FEFD disabled when the global configuration changes, use
the fefd reset command.
1060
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
fefd disable — disables far-end failure detection on an interface.
fefd reset — enables FEFD globally on the system.
fefd mode — changes FEFD mode on an interface.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Layer 2