Service-Class Dot1P-Mapping - Dell S4810 Reference Manual

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 7.6.1.0
pre-Version
6.1.1.1
Usage
On 40-port 10G stack-unit if the traffic is shaped between 64 and 1000 Kbs, for
Information
some values, the shaped rate is much less than the value configured
Related rate-shape
Commands

service-class dot1p-mapping

Configure a service-class criterion based on a dot1p value.
S4810
Syntax
service-class dot1p-mapping {dot1p0 queue | dot1p1 queue |
dot1p2 queue | dot1p3 queue | dot1p4 queue| dot1p5 queue |
dot1p6 queue | dot1p7 queue}
Parameters
queue
Defaults For each dot1p Priority, the default CoS queue value is:
•
•
Command CONFIGURATION
Modes
Quality of Service (QoS)
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added the kbps option on the C-Series, E-Series, and S-
Series.
Introduced on the S-Series and C-Series.
Introduced on the E-Series.
NOTE: When packets of size greater than 7000 bytes are expected to be
received from the network, Dell Networking recommends that you configure
the burst value to be more than 175 KB if you configured the rate shape. Such
a setting ensures proper bandwidth sharing across queues.
— shapes traffic output as part of the designated policy.
Enter a value from 0 to 7.
Dot1p Priority : 0 1 2 3 4 5 6 7
Queue : 2 0 1 3 4 5 6 7
1331