Permit - Dell S4810 Reference Manual

Version 7.8.1.0
Version 7.4.1.0

permit

To configure a filter that matches the filter criteria, select an IPv6 protocol number, ICMP, IPv6, TCP, or
UDP.
S4810
Syntax
permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp}
To remove this filter, you have two choices:
•
•
Parameters
ip-protocol-
number
icmp
ipv6
tcp
udp
Defaults Not configured.
Command ACCESS-LIST
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
IPv6 Access Control Lists (IPv6 ACLs)
Introduced on the C-Series.
Introduced on the E-Series TeraScale. Added the monitor
option.
Use the no seq sequence-number command syntax if you know the filter's
sequence number
Use the no permit {ipv6-protocol-number | icmp | ipv6 | tcp |
udp} command
Enter an IPv6 protocol number. The range is from 0 to 255.
Enter the keyword icmp to filter internet Control Message
Protocol version 6.
Enter the keyword ipv6 to filter any internet Protocol
version 6.
Enter the keyword tcp to filter the Transmission Control
protocol.
Enter the keyword udp to filter the User Datagram Protocol.
Introduced on the S6000.
Introduced on the S4820T.
911