Show Ip Interface - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:
Table of Contents

Advertisement

Version 7.9.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage
This command provides egress port information for a given IP flow. This
Information
information is useful in identifying which interface the packet follows in the case of
Port-channel and Equal Cost Multi Paths. Use this command for routed packed
only. For switched packets, use the show port-channel-flow command.
The show ip flow command does not compute the egress port information
when load-balance mac hashing is also configured due to insufficient
information (the egress MAC is not available).
S-Series produces the following error message: %Error: Unable to read IP
route table.
Example
Dell#show ip flow interface Gi 1/8 189.1.1.1 63.0.0.1 protocol
tcp source-port 7898 destination-port 8
flow: 189.1.1.1 63.0.0.1 protocol 6 7868 8976
Ingress interface:Gi 1/20
Egress interface:Gi 1/14 to 1.7.1.2[CAM hit 103710]
unfragmented packet
packet

show ip interface

View IP-related information on all interfaces.
S4810
Syntax
show ip interface [interface | brief] [configured]
Parameters
interface
IPv4 Routing
Introduced VRF on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Gi 1/10 to 1.2.1.2[CAM hit 103710] fragmented
(OPTIONAL)
Enter the following keywords and slot/port or number
information:
For a Loopback interface, enter the keyword Loopback
then a number from 0 to 16383.
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
For the Management interface, enter the keyword
ManagementEthernet then zero (0).
889

Advertisement

Table of Contents
loading

Table of Contents