Dell S4810 Reference Manual page 1043

Column Heading
State
Example
Dell(conf)#do show mac-address-table
Codes: *N - VLT Peer Synced MAC
VlanId
Address
2
128
2
10
2
100
2
10
Usage
The following describes the show mac-address-table command shown in the
Information
following example.
Column Heading
VlanId
Mac Address
Type
Interface
State
The following describes the show mac-address-table count command shown
in the following example.
Line Beginning
With
MAC Entries...
Dynamic
Address...
Static Address...
Layer 2
Description
Lists if the MAC address is in use (Active) or not in use
(Inactive).
Mac
Type
00:00:00:00:00:01
Active
00:00:00:00:00:02
Active
00:00:00:00:00:03
Active
00:00:00:00:00:04
Active
Description
Displays the VLAN ID number.
Displays the MAC address in nn:nn:nn:nn:nn:nn format.
Lists whether the MAC address was manually configured
(Static), learned (Dynamic), or associated with a specific port
(Sticky). An (N) indicates that the specified MAC address has
been learnt by a neighbor and is synced to the node.
Displays the interface type and slot/port information. The
following abbreviations describe the interface types:
• gi — Gigabit Ethernet followed by a slot/port
• po — Port Channel followed by a number. Range for
Terascale is from 1 to 255. \
• so — Sonet followed by a slot/port.
• te — 10–Gigabit Ethernet followed by a slot/port.
Lists if the MAC address is in use (Active) or not in use
(Inactive).
Description
Displays the number of MAC entries learned per VLAN.
Lists the number of dynamically learned MAC addresses.
Lists the number of user-defined MAC addresses.
Interface State
Dynamic (N) Po
Dynamic (N) Po
Dynamic
Dynamic
Po
Po
1043