Show Running-Config Ecmp-Group; Shutdown - Dell S4810 Reference Manual

Example
Dell(conf-if-range-so-2/0-1,fa-0/0)#show range
interface sonet 2/0 - 1
interface fastethernet 0/0
Dell(conf-if-range-so-2/0-1,fa-0/0)#
Related
interface
Commands
show ip interface
show interfaces
interface.

show running-config ecmp-group

Display interfaces, LAG, or LAG link bundles being monitored for uneven traffic distribution using the
ecmp-group monitoring enable command. The ECMP group could have a LAG or a list of 10G/40
interfaces (not just LAG link-bundles).
S4810
Syntax
show running-config ecmp-group
Defaults Disabled.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.3.11.1
Version
8.3.10.0
Related ecmp-group
Commands

shutdown

Disable an interface.
S4810
Syntax
shutdown
To activate an interface, use the no shutdown command.
790
— configures a physical interface on the switch.
— displays Layer 3 information about the interfaces.
— displays information on a specific physical interface or virtual
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
— configures a mechanism to monitor traffic distribution.
Interfaces