Redundancy Auto-Failover-Limit - Dell S4810 Reference Manual

Related show processes restartable
Commands

redundancy auto-failover-limit

Specify an auto-failover limit for RPMs. When a non-recoverable fatal error is detected, an automatic
RPM failover occurs. This command does not affect user-initiated (manual) failovers.
S4810
Syntax
redundancy auto-failover-limit [count number [period minutes] |
period minutes]]
To disable the auto-failover limit control, use the no redundancy auto-
failover-limit command.
Parameters
count number
period minutes
Default
•
•
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version
8.3.12.0
Version 8.1.1.0
Version 7.5.1.0
Version 7.6.1.0
High Availability (HA)
Enter the number of times the RPMs can automatically
failover within the period defined in the period parameter.
The range is from 2 to 10. The default is 3.
Enter a duration in which to allow a number of automatic
failovers (limited to the number defined in the count
parameter). The range is from 5 to 9000 minutes. The
default is 60 minutes.
Count: 3
Period: 60 minutes
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Introduced on the E-Series
695