Dell S4810 Reference Manual page 1155

Field
aut:
auk:
keyid:
to:
dst:
netmask:
pri:
N, MC, E, T
hi:
di:
dr:
bdr:
Example
Dell#debug ip ospf 1 packet
OSPF process 90, packet debugging is on
Dell#
08:14:24 : OSPF(100:00):
Xmt. v:2 t:1(HELLO) l:44 rid:192.1.1.1
Open Shortest Path First (OSPFv2 and OSPFv3)
Description
States if OSPF authentication is configured. One of the
following is listed:
• 0 - no authentication configured
• 1 - simple authentication configured using the ip ospf
authentication-key command
• 2 - MD5 authentication configured using the ip ospf
message-digest-key command
If the ip ospf authentication-key command is
configured, this field displays the key used.
If the ip ospf message-digest-key command is
configured, this field displays the MD5 key
Displays the interface to which the packet is intended.
Displays the destination IP address.
Displays the destination IP address mask.
Displays the OSPF priority
Displays information available in the Options field of the
HELLO packet:
• N + (N-bit is set)
• N - (N-bit is not set)
• MC+ (bit used by MOSPF is set and router is able to
forward IP multicast packets)
• MC- (bit used by MOSPF is not set and router cannot
forward IP multicast packets)
• E + (router is able to accept AS External LSAs)
• E - (router cannot accept AS External LSAs)
• T + (router can support TOS)
• T - (router cannot support TOS)
Displays the amount of time configured for the HELLO
interval.
Displays the amount of time configured for the DEAD
interval.
Displays the IP address of the designated router.
Displays the IP address of the Border Area Router.
aid:0.0.0.1 chk:0xa098 aut:0 auk: keyid:0 to:Gi 4/3 dst:
1155