Clear Host; Clear Ip Fib Stack-Unit - Dell S4810 Reference Manual

clear host

Remove one or all dynamically learned host table entries.
S4810
Syntax
clear host name
Parameters
name
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0

clear ip fib stack-unit

Clear all FIB entries in the specified stack unit (use this command with caution, refer to Usage
Information.)
S4810
Syntax
clear ip fib stack-unit unit-number vrf vrf-name
Parameters
unit-number
vrf vrf-name
Command EXEC Privilege
Modes
838
Enter the name of the host to delete. Enter * to delete all
host table entries.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Enter the number of the stack unit. The range is from 0 to 11.
Enter the keyword vrf followed by the name of the VRF to
clear all FIB entries corresponding to that VRF.
IPv4 Routing