Redundancy Force-Failover Stack-Unit - Dell S4810 Reference Manual

Version
8.3.19.0
Version 8.3.7.0
Version 8.3.11.1
Version 8.3.1.0
Version 7.7.1.0
Usage The range is 0 to 11. Enabling this command keeps the failed switch in the Failed
Information state. The switch does not reboot until it is manually rebooted. When enabled, it is
not displayed in the running-config. When disabled, it is displayed in the running-
config.
Related show redundancy
Commands

redundancy force-failover stack-unit

Force the standby unit in the stack to become the management unit.
S4810
Syntax
redundancy force-failover stack-unit
Parameters
stack-unit
Defaults Not enabled.
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.3.7.0
Version 8.3.11.1
Version 8.3.1.0
Version 7.7.1.0
1608
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Added the members option.
Introduced on the S-Series.
— displays the current redundancy status.
Enter the stack unit. For the S4810, the range is from 0 to 5.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Added the members option.
Introduced on the S-Series.
Stacking