Ipv6 Control-Plane Egress-Filter; Ipv6 Access-List - Dell S4810 Reference Manual

Version 8.3.7.0

ipv6 control-plane egress-filter

Enable egress Layer 3 ACL lookup for IPv6 CPU traffic.
S4810
Syntax
ipv6 control-plane egress-filter
Defaults Not enabled.
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.0.0.0
Version
8.3.19.0
Version
8.3.10.0

ipv6 access-list

Configure an access list based on IPv6 addresses or protocols.
S4810
Syntax
ipv6 access-list access-list-name cpu-qos {permit | deny}
ospfv3
To delete an access list, use the no ipv6 access-list access-list-name
command.
Parameters
access-list-
name
cpu-qos
912
Introduced on the S4810.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Enter the access list name as a string, up to 140 characters.
Enter the keyword cpu-qos to assign this ACL to control
plane traffic only (CoPP).
IPv6 Access Control Lists (IPv6 ACLs)