Ip Max-Frag-Count - Dell S4810 Reference Manual

Example
Dell(conf)#ipv6 icmp source-interface tengigabitethernet 0/0
Dell(conf)#

ip max-frag-count

Set the maximum number of fragments allowed in one packet for packet re-assembly.
S4810
Syntax
ip max-frag-count count
To place no limit on the number of fragments allowed, use the no ip max-frag-
count command.
Parameters
count
Defaults No limit is set on number of fragments allowed.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage To avoid denial of service (DOS) attacks, keep the number of fragments allowed for
Information re-assembly low.
IPv4 Routing
Enter a number for the number of fragments allowed for re-
assembly. The range is from 2 to 256.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced for the E-Series.
859