Speed (For 10/100/1000 Interfaces) - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

speed (for 10/100/1000 interfaces)

Set the speed for 10/100/1000 Base-T Ethernet interfaces. Set both sides of a link to the same speed

(10/100/1000) or to auto or the link may not come up.

speed {10 | 100 | 1000 | auto}

To return to the default setting, use the no speed {10 | 100 | 1000}

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 8.3.11.1

Version 8.3.7.0

Enter the keyword 10 to set the interface's speed to 10 Mb/s.

NOTE: This interface speed is not supported on the LC-

EH-GE-50P or the LC-EJ-GE-50P card. If the command

is entered for these interfaces, an error message appears.

Enter the keyword 100 to set the interface's speed to 10/100

NOTE: When this setting is enabled, only 100Base-FX

optics are supported on the LC-EH-GE-50P or the LC-

EJ-GE-50P card.

Enter the keyword 1000 to set the interface's speed to 1000

Mb/s. Auto-negotiation is enabled. For more information,

refer to negotiation auto.

NOTE: When this setting is enabled, only 100oBase-FX

optics are supported on the LC-EH-GE-50P or the LC-

EJ-GE-50P card.

Enter the keyword auto to set the interface to auto-

negotiate its speed. Auto-negotiation is enabled. For more

information, refer to negotiation auto.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.