Ip Tacacs Source-Interface - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

EXEC Privilege

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Version 8.3.7.0

Version 7.6.1.0

Version 7.5.1.0

ip tacacs source-interface

Specify an interface's IP address as the source IP address for TACACS+ connections.

ip tacacs source-interface interface

To delete a source interface, use the no ip tacacs source-interface

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.

Enter the following keywords and slot/port or number

information:

For a 100/1000 Ethernet interface, enter the keyword

GigabitEthernet then the slot/port information.

For a Gigabit Ethernet interface, enter the keyword

GigabitEthernet then the slot/port information.

For Loopback interfaces, enter the keyword loopback

then a number from zero (0) to 16838.

For the Null interface, enter the keywords null 0.

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

For a ten-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.