Ip Max-Routes; Ip Mtu - Dell S4810 Reference Manual

ip max-routes

Enables you to configure the maximum number of protocol routes per VRF that are allowed for IPv4.
S4810
Syntax
ip max-routes [vrf vrf-name] max-number
Parameters
vrf vrf-name
max-number
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Usage Use this command to specify the maximum number of protocol routes that the
Information Route Table Manager can hold for a specific VRF. This command does not apply to
the management VRFs.
Related show ip route
Commands
show ipv6 route

ip mtu

Set the IP MTU (frame size) of the packet the RPM transmits for the line card interface. If the packet must
be fragmented, Dell Networking OS sets the size of the fragmented packets to the size specified in this
command.
S4810
Syntax
ip mtu value
To return to the default IP MTU value, use the no ip mtu command.
Parameters
value
860
Enter the keyword vrf and then the name of the VRF for
which you want to configure maximum number of protocol
routes that IPv4 allows.
Enter the maximum number of protocol routes that a VRF
RTM can hold. The range is from 0 to 7500.
Introduced on the S4810 and S4820T.
— views the switch routing table.
— displays the IPv6 routes.
Enter the maximum MTU size if the IP packet is fragmented.
The range is from 576 to 9234. The default is 1500 bytes.
IPv4 Routing