Show Ip Route Summary - Dell S4810 Reference Manual

show ip route summary

View a table summarizing the IP routes in the switch.
S4810
Syntax
show ip route vrf vrf-name summary
Parameters
vrf vrf-name
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4(0.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage The following describes the show ip route summary shown in the following
Information example.
Column Heading
Route Source
Active Routes
Non-active
Routes
900
Enter the keyword vrf followed by the name of the VRF to
view information on the IP routes corresponding to that VRF.
EXEC
EXEC Privilege
Added support for VRF.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Identifies how the route is configured in Dell Networking
OS.
Identifies the best route if a route is learned from two
protocol sources.
Identifies the back-up routes when a route is learned by two
different protocols. If the best route or active route goes
down, the non-active route becomes the best route.
IPv4 Routing