Debug Gvrp - Dell S4810 Reference Manual

Related show gvrp statistics
Commands

debug gvrp

Enable debugging on GVRP.
S4810
Syntax
debug gvrp {config | events | pdu}
To disable debugging, use the no debug gvrp {config | events | pdu}
command.
Parameters
config
event
pdu
Defaults Disabled.
Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
GARP VLAN Registration (GVRP)
— displays the GVRP statistics.
Enter the keyword config to enable debugging on the
GVRP configuration.
Enter the keyword event to enable debugging on the JOIN/
LEAVE events.
Enter the keyword pdu then one of the following Interface
keywords and slot/port or number information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on C-Series, E-Series, and S-Series
683