Show Ip Flow - Dell S4810 Reference Manual

show ip flow

Show how a Layer 3 packet is forwarded when it arrives at a particular interface.
S4810
Syntax
show ip flow interface interface {source-ip address
destination-ip address} {protocol number [tcp | udp]} {src-port
number destination-port number}
Parameters
interface
interface
source-ip
address
destination-ip
address
protocol
number [tcp |
udp]
src-port
number
destination-
port number
Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version
8.3.10.0
Version 8.5.1.0
Version 8.1.1.0
888
Enter the keyword interface then one of the following
interface keywords.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Enter the keywords source-ip then the IP source address
in IP address format.
Enter the keywords destination-ip then the IP
destination address in IP address format.
Enter the keyword protocol then one of the protocol type
keywords: tcp, udp, or protocol number The protocol
number range is from 0 to 255. .
Enter the keywords src-port then the source port number.
Enter the keywords destination-port then the destination
port number.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the E-Series ExaScale.
IPv4 Routing