Mac-Address-Table Static - Dell S4810 Reference Manual

Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Related
mac learning-limit
Commands
show mac-address-table aging-time

mac-address-table static

Associate specific MAC or hardware addresses to an interface and VLANs.
S4810
Syntax
mac-address-table static mac-address {multicast vlan vlan-id
output—range interface}{output interface vlan vlan-id}
To remove a MAC address, use the no mac-address-table static mac-
address output interface vlan vlan-id command.
Parameters
mac-address
multicast
output
interface
1030
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
On the E-Series, available in INTERFACE VLAN context,
reduced the minimum aging time in the INTERFACE VLAN
context from 10 seconds to 1 second.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— sets the MAC address learning limits for a selected interface.
— displays the MAC aging time.
Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn
format.
Enter a vlan port to where L2 multicast MAC traffic is
forwarded.
NOTE: Use this option if you want multicast functionality
in an L2 VLAN without IGMP protocols.
For a unicast MAC address, enter the keyword output then
one of the following interfaces for which traffic is forwarded:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Layer 2