Crypto Ipsec Policy - Dell S4810 Reference Manual

Usage
•
Information
•
Example
Dell(conf)#do show crypto ipsec transform-set
Transform-Set Name
Transform-Set refCnt
AH Transform
ESP Auth Transform
ESP Encry Transform
Dell(conf)#

crypto ipsec policy

Create a crypto policy used by ipsec.
S4810
Syntax
crypto ipsec policy name seq-num ipsec-manual
To delete a crypto policy entry, use the no crypto ipsec policy name seq-
num ipsec-manual command.
Parameters
name
seq-num
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.2)
Usage This command creates a crypto policy entry and enters the crypto policy
Information configuration mode for configuring the flow parameters.
Example
Dell(conf)#crypto ipsec policy West 10 ipsec-manual
Dell(conf-crypto-policy)#
Internet Protocol Security (IPSec)
Both sides of the link must specify the same transform set.
You can create up to 64 transform sets.
Enter the name for the crypto policy set.
Enter the sequence number assigned to the crypto policy
entry.
Introduced on the Z9000, S4810, and S4820T.
: ts1
: 0
: md5
:
:
825