Show Isis Traffic - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

Redistributing:

Distance: 115

Generate narrow metrics: level-1-2

Accept narrow metrics:

Generate wide metrics:

Accept wide metrics:

Multi Topology Routing is enabled in transition mode.

show isis traffic

This command allows you to display IS-IS traffic interface information.

show isis traffic [interface]

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Intermediate System to Intermediate System (IS-IS)

System Id: F100.E120.0013 IS-Type: level-1-2

Manual area address(es):

49.0000.0001

Routing for area address(es):

49.0000.0001

Interfaces supported by IS-IS:

GigabitEthernet 1/0 - IP - IPv6

GigabitEthernet 1/1 - IP - IPv6

GigabitEthernet 1/10 - IP - IPv6

Loopback 0 - IP - IPv6

(OPTIONAL) Identifies the interface type slot/port as one of

the following:

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a Gigabit Ethernet interface, enter the keyword

GigabitEthernet then the slot/port information.

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a VLAN, enter the keyword vlan then a number from

EXEC Privilege