Router Isis - Dell S4810 Reference Manual

Usage How a metric value assigned to a redistributed route is advertised depends on how
Information on the configuration of the metric-style command. If the metric-style
command is set for Narrow mode and the metric value in the redistribute
ospf command is set to a number higher than 63, the metric value advertised in
LSPs is 63. If the metric-style command is set for wide mode, the metric value
in the redistribute ospf command is advertised.

router isis

Allows you to enable the IS-IS routing protocol and to specify an IP IS-IS process.
S4810
Syntax
router isis [tag]
To disable IS-IS routing, use the no router isis [tag] command.
Parameters
tag
Defaults Not configured.
Command ROUTER ISIS
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Version 8.3.11.1
Usage
Configure a network entity title (the net command) to specify the area address and
Information
the router system ID.
Enable routing on one or more interfaces to establish adjacencies and establish
dynamic routing.
1006
(OPTIONAL) This is a unique name for a routing process. A
null tag is assumed if the tag option is not specified. The tag
name must be unique for all IP router processes for a given
router.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Intermediate System to Intermediate System (IS-IS)