Redistribute - Dell S4810 Reference Manual

•
•
•
passive-interface default
•
•
•
•
no passive-interface interface
•
•
•
No passive-interface default
•
•
•
On configuring suppression using the passive-interface command, the state of the
OSPF neighbor does not change to INIT; instead, the state of the OSPF neighbor
changes to DOWN after the dead-timer expires.

redistribute

Redistribute information from another routing protocol throughout the OSPF process.
S4810
Syntax
redistribute {connected | isis | ospf | rip | static} [metric
metric-value | metric-type type-value] [route-map map-name]
[tag tag-value]
To disable redistribution, use the no redistribute {connected | isis |
rip | static} command.
Parameters
connected
isis
ospf
Open Shortest Path First (OSPFv2 and OSPFv3)
The previous no passive-interface interface is removed from the
running configuration.
The ABR status for the router is updated.
Save passive-interface interface into the running configuration.
All present and future OSPF interfaces are marked as passive.
Any adjacency is explicitly terminated from all OSPF interfaces.
All previous passive-interface interface commands are removed from
the running configuration.
All previous no passive-interface interface commands are removed
from the running configuration.
Remove the interface from the passive list.
The ABR status for the router is updated.
If passive-interface default is specified, then save no passive-
interface interface into the running configuration.
Clear everything and revert to the default behavior.
All previously marked passive interfaces are removed.
May update ABR status.
Enter the keyword connected to specify that information
from active routes on interfaces is redistributed.
Enter the keyword isis to specify that ISO IS-IS information is
redistributed.
Enter the keyword ospf to specify that information
corresponding to OSPF is redistributes.
1181