Dell S4810 Reference Manual page 1585

To disable logging, use the no logging command.
Parameters
ip-address
ipv6-address
hostname
udp
tcp
vrf vrf-name
Defaults Disabled.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0)
Version 9.4.
(0.0)
Version 9.2(1.0)
Version 9.0.2.0
Version 9.2(0.0)
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.4.1.0
Simple Network Management Protocol (SNMP) and Syslog
Enter the IPv4 address in dotted decimal format.
Enter the IPv6 address in the x:x:x:x::X format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Enter the name of a host already configured and recognized
by the switch.
Enter the keyword udp to enable transmission of log
message over UDP followed by port number. The default
port is 514
Enter the keyword tcp to enable transmission of log
message over TCP followed by port number.
(Optional) Enter the keyword vrf and then the name of the
VRF to enable the logging process in VRF mode.
NOTE: Use this attribute to specify the VRF that is used
to contact the host. By default, the default VRF is used.
Added udp and tcp keywords for the S4810, S4820T, S6000,
Z9000, and MXL.
Added support for VRF.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for IPv6.
1585