Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
pre-Version
6.2.1.1
router rip
To configure and enable RIP, enter ROUTER RIP mode.
S4810
Syntax
router rip
To disable RIP, use the no router rip command.
Defaults
Disabled.
Command
CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
pre-Version
6.2.1.1
Usage
To enable RIP, assign a network address using the network command.
Information
Example
Dell(conf)#router rip
Dell(conf-router_rip)#
Routing Information Protocol (RIP)
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
1401