Ipv6 Ospf Cost - Dell S4810 Reference Manual

multiplier value
role [active |
passive]
Defaults See Parameters
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2.0.0
Usage
This command provides the flexibility to fine-tune the timer values based on
Information
individual interface needs when you configure ipv6 ospf BFD in CONFIGURATION
mode. Any timer values specified with this command overrides timers set using the
bfd all-neighbors command. Using the no form of this command does not
disable BFD if you configure BFD in CONFIGURATION mode.
To disable BFD on a specific interface while you configure BFD in
CONFIGURATION mode, use the keyword disable.

ipv6 ospf cost

Explicitly specify the cost of sending a packet on an interface.
S4810
Syntax
ipv6 ospf interface-cost
Parameters
interface-cost
Defaults Default cost based on the bandwidth.
Open Shortest Path First (OSPFv2 and OSPFv3)
remote system. The range is from 50 to 100. The default is
100.
Enter the keyword multiplier to specify the number of
packets that must be missed in order to declare a session
down. The range is from 3 to 50. The default is 3.
Enter the role that the local system assumes:
• Active — The active system initiates the BFD session.
Both systems can be active for the same session.
• Passive — The passive system does not initiate a
session. It only responds to a request for session
initialization from the active system.
The default is Active.
Introduced on the Z9000, S4820T, and S4810.
Enter a unsigned integer value expressed as the link-state
metric. The range is from 1 to 65535.
1239