Dell S4810 Reference Manual page 1042

Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version
8.3.12.0
Version 8.5.1.0
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage The following describes the show mac-address-table command shown in the
Information
following example.
Column Heading
VlanId
Mac Address
Type
Interface
1042
static addresses, dynamic addresses, and MAC addresses in
use.
EXEC
EXEC Privilege
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Updated the output.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Displays the VLAN ID number.
Displays the MAC address in nn:nn:nn:nn:nn:nn format.
Lists whether the MAC address was manually configured
(Static), learned dynamically (Dynamic), or associated with a
specific port (Sticky).
Displays the interface type and slot/port information. The
following abbreviations describe the interface types:
• gi — Gigabit Ethernet then a slot/port.
• po — Port Channel then a number. The range is from 1
to 255 for TeraScale.
• so —SONET then a slot/port.
• te — 10 Gigabit Ethernet then a slot/port.
Layer 2