Clear Ipv6 Route; Clear Ipv6 Mld_Host - Dell S4810 Reference Manual

clear ipv6 route

Clear (refresh) all or a specific route from the IPv6 routing table.
S4810
Syntax
clear ipv6 route {* | ipv6-address prefix-length}
Parameters
*
ipv6-address
prefix-length
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.0.0
Version
8.3.19.0
Version 8.3.7.0
Version 8.2.1.0
Version 7.8.1.0
Version 7.4.1.0

clear ipv6 mld_host

Clear the IPv6 MLD host counters and reset the elapsed time.
S4810
Syntax
clear ipv6 mld_host
Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
918
Enter the * to clear (refresh) all routes from the IPv6 routing
table.
Enter the IPv6 address in the x:x:x:x::x format then the prefix
length in the /x format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series and S-Series.
Introduced on the E-Series TeraScale.
IPv6 Basics