Radius-Server Timeout - Dell S4810 Reference Manual

radius-server timeout

To reply to a request, configure the amount of time the RADIUS client (the switch) waits for a RADIUS
host server .
S4810
Syntax
radius-server timeout seconds
To return to the default value, use the no radius-server timeout command.
Parameters
seconds
Defaults 5 seconds
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.0
Related radius-server host
Commands
TACACS+ Commands
Dell Networking OS supports TACACS+ as an alternate method for login authentication.
Security
Enter the number of seconds between an unsuccessful
attempt and the Dell Networking OS times out. The range is
from zero (0) to 1000 seconds. The default is 5 seconds.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— configures a RADIUS host.
1479