Show Ip Ospf - Dell S4810 Reference Manual

Version 7.5.1.0
pre-Version
6.1.1.1
Example
Dell(conf-router_ospf)#show config
!
router ospf 3
passive-interface FastEthernet 0/1
Dell(conf-router_ospf)#

show ip ospf

Display information on the OSPF process configured on the switch.
S4810
Syntax
show ip ospf [process-id | vrf vrf name]
Parameters
process-id
vrf vrf name
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.8.0
Version 8.3.7.0
Version 7.9.1.0
Version 7.8.1.0
Version 7.8.1.0
1188
Introduced on the C-Series.
Introduced on the E-Series.
Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
Show only the OSPF information tied to the VRF process.
EXEC
EXEC Privilege
Added support for VRF.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Added output for LSA throttling timers.
Introduced on the S4810.
Added support for VRF.
Added support of Multi-Process OSPF.
Added the process-id option, in support of Multi-Process
OSPF.
Open Shortest Path First (OSPFv2 and OSPFv3)