Ip Ospf Hello-Interval - Dell S4810 Reference Manual

ip ospf hello-interval

Specify the time interval between the hello packets sent on the interface.
S4810
Syntax
ip ospf hello-interval seconds
To return to the default value, use the no ip ospf hello-interval command.
Parameters
seconds
Defaults 10 seconds
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Usage The time interval between the hello packets must be the same for routers in a
Information network.
Related ip ospf dead-interval
Commands
ip ospf message-digest-key
Enable OSPF MD5 authentication and send an OSPF message digest key on the interface.
S4810
Syntax
ip ospf message-digest-key keyid md5 key
To delete a key, use the no ip ospf message-digest-key keyid command.
Open Shortest Path First (OSPFv2 and OSPFv3)
Enter the number of seconds for the interval. The range is
from 1 to 65535. The default is 10 seconds.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— sets the time interval before a router is declared dead.
1171