Dell S4810 Reference Manual page 1264

source
mask
any
host ip-address
destination
operator
Defaults none
Command REDIRECT-LIST
Modes
Command
Version 9.4.0.0
History
Version 8.4.2.1
Version 8.4.2.0
seq
Configure a filter with an assigned sequence number for the redirect list.
S4810
Syntax
seq sequence-number {permit | redirect {ip-address}} {ip-
protocol-number | protocol-type} {source mask | any | host ip-
address} {destination mask | any | host ip-address} [bit]
[operator]{source-port source-port| source-port-range start-
port - end-port} {destination-port destination-port|
destination-port-range start-port - end-port}
To delete a filter, use the no seq sequence-number command.
1264
Enter the IP address of the network or host from which the
packets were sent.
Enter a network mask in /prefix format (/x).
Enter the keyword any to specify that all traffic is subject to
the filter.
Enter the keyword host then the IP address to specify a host
IP address.
Enter the IP address of the network or host to which the
packets are sent.
(OPTIONAL) For TCP and UDP parameters only. Enter one of
the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two
ports for theport command parameter.)
Introduced on the S4810.
Introduced on the C-Series.
Introduced on the E-Series TeraScale.
Policy-based Routing (PBR)