Ipv6 Address Autoconfig - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

The following is a list of the Dell Networking OS version history for this command.

Version 8.3.11.1

ipv6 address autoconfig

Configure IPv6 address auto-configuration for the management interface.

ipv6 address autoconfig

To disable the address autoconfig operation on the management interface, use the

no ipv6 address autoconfig command.

INTERFACE (management interface only)

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.1.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the Z9000.

Updated Usage Information section.

Introduced on the S4820T.

Introduced on the S4810.

SAA can configure up to two addresses. If any preferred prefix or valid timers

time out, the corresponding address are deprecated or removed. If an address

is removed due to a time-out, an address from the current unused prefix is used

to create a new address. If there are no remaining prefixes, the software waits

to receive a new prefix from the RA.

If auto-configuration is enabled, all IPv6 addresses on that management

interface are auto-configured. Manual and auto-configurations are not

supported on a single management interface.