Mac-Address-Table Static (For Multicast Mac Address) - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

Not configured.

CONFIGURATION

Version 9.3(0.0)

For multicast mode of NLB, to associate an IP address with a multicast MAC

address in the switch, use address resolution protocol (ARP) by entering the arp

ip-address multicast-mac-address command in Global configuration

mode. This setting causes the multicast MAC address to be mapped to the cluster

IP address for NLB mode of operation of the switch.

clear arp-cache

mac-address-table static (for Multicast MAC Address)

For multicast mode of network load balancing (NLB), configure a static multicast MAC address, associate

the multicast MAC address with the VLAN used to switch Layer 2 multicast traffic, and add output ports

that will receive multicast streams on the VLAN. To delete a configured static multicast MAC address from

the MAC address table on the router, enter the no mac-address-table static multicast-mac-

address command.

mac-address-table static multicast-mac-address multicast vlan

vlan-id range-output {single-interface | interface-list |

interface-range}

To remove a MAC address, use the no mac-address-table static

multicast-mac-address output interface vlan vlan-id command.

multicast-mac-

Microsoft Network Load Balancing

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

The interface specified here must be one of the

interfaces configured using the {output-range |

output} interface option with the mac-address-

table static command.

Added support for association of an IP address with multicast

MAC address on the S4810, S4820T, S6000, and Z9000

— clears dynamic ARP entries from the ARP table.

— displays the ARP table.

Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn

Enter a vlan port to where L2 multicast MAC traffic is