Tacacs-Server Vrf - Dell S4810 Reference Manual

tacacs-server vrf

Create an association between a TACACS server group and a VRF and source interface..
S4810
Syntax
tacacs-server vrf vrf-name [source-interface interface]
To delete the association between a TACACS server group and a VRF and source
interface, use the no tacacs-server vrf vrf-name [source-interface
interface] command.
Parameters
vrf vrf-name
interface
Defaults Not configured.
Command TACACS SERVER GROUP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Usage
You can use this command to associate a group of TACACS servers with a VRF and
Information
source interface. You can configure the source interface only with the VRF
attribute and source interface is optional with the VRF attributes.
1486
Enter the keyword vrf and then the name of the VRF to
associate a TACACS server group with that VRF.
Enter the following keywords and slot/port or number
information:
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For Loopback interfaces, enter the keyword loopback
then a number from zero (0) to 16838.
• For the Null interface, enter the keywords null 0.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Introduced on the S-Series and Z-Series.
Security