Equal Cost Multi-Path (Ecmp); Ecmp-Group - Dell S4810 Reference Manual

Equal Cost Multi-Path (ECMP)

Equal cost multi-path (ECMP) is supported on the Dell Networking S4810 platform.

ecmp-group

Provides a mechanism to monitor traffic distribution on an ECMP link bundle. A system log is generated
when the standard deviation of traffic distribution on a member link exceeds a defined threshold.
S4810
Syntax
ecmp-group {ecmp-group-id interface interface | link-bundle-
monitor}
To remove the selected interface, use the ecmp-group no interface
command.
To disable link bundle monitoring, use the ecmp-group no link-bundle-
monitor command.
Parameters
ecmp-group ID
interface
Defaults Off
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
636
Enter the identifier number for the ECMP group. The range is
from 2 to 64.
Enter the following keywords and slot/port to add the
interface to the ECMP group:
• 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information
• For a LAG interface, enter the keywords port-channel
then the slot/port information. The range is from 1 to 128.
CONFIGURATION
CONFIGURATION ECMP-GROUP
16
Equal Cost Multi-Path (ECMP)