Ip Ssh Source-Interface - Dell S4810 Reference Manual

To disable the SSH server configuration, use the no ip ssh server vrf
{management | vrf-name} command.
Parameters
vrf
management
vrf vrf-name
Defaults None
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Usage
You can enable the SSH server on either a management VRF or a user defined VRF
Information
but not both. If no VRF is specified, then the SSH server is enabled on the default
VRF.
If the SSH server is enabled on a VRF with name vrf1, then use the following
command to restart the SSH server on a VRF with name vrf2: ip ssh server
vrf vrf2. If the SSH server is enabled on a VRF with name vrf1, then use the
following command to restart the SSH server on the default VRF: ip ssh server
vrf.
Example
•
•
•
•
Related show ip ssh
Commands

ip ssh source-interface

Specifies an interface's IP address as the source IP address for an outgoing SSH connections.
S4810
Syntax
ip ssh source-interface interface
To delete a source interface, use the no ip ssh source-interface command.
Security
Enter the key word vrf followed by the keyword
management to configure an SSH server on a management
VRF.
Enter the key word vrf followed by the VRF name to
configure an SSH server on that VRF.
Introduced on the S-Series and Z-Series.
Dell(conf)#ip ssh server vrf vrf1
Dell(conf)#no ip ssh server vrf
Dell(conf)#ip ssh server vrf management
Dell(conf)#no ip ssh server vrf
— displays the ssh information.
1513