Show Iscsi - Dell S4810 Reference Manual

Parameters
tcp-
port-2...tcpport
- 16
ip-address
(Optional)
Defaults 860, 3260
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version
8.3.12.0
Version
8.3.16.0
Usage
You can configure up to 16 target TCP ports on the switch in one command or
Information
multiple commands.
When you use the no iscsi target port command and the TCP port you wish
to delete is one bound to a specific IP address, the IP address value must be
included in the command.

show iscsi

Display the currently configured iSCSI settings.
S4810
Syntax
show iscsi
Command
•
Modes
•
948
Enter the tcp-port number of the iSCSI target ports. The
tcp-port-n is the TCP port number or a list of TCP port
numbers on which the iSCSI target listens to requests.
Separate port numbers with a comma. The default is 860,
3260.
Enter the ip-address that the iSCSI monitors. The ip-address
specifies the IP address of the iSCSI target.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on MXL 10/40GbE Switch IO Module.
EXEC
EXEC Privilege
iSCSI Optimization