Process Restartable - Dell S4810 Reference Manual

identifies that this patch applies to Dell Networking OS version 7.8.1.0 — E-Series
platform, for RP2, addressing the layer 2 management process, and this patch is
the first version of this patch.
There is no need to reload or reboot the system when you insert the patch. The In-
Service Modular patch replaces the existing process code. After installation is
complete, the system executes the patch code as though it was always there.
Related show patch
Commands
hot fix command.

process restartable

Enable a process to be restarted. Restartability is subject to a maximum restart limit. This limit is defined
as a configured number of restarts within a configured amount of time. On the software exception that
exceeds the limit, the system reloads (for systems with a single RPM) or fails over (for systems with dual
RPMs).
S4810
Syntax
process restartable [process] [count number] [period minutes]
Parameters
process
count number
period minutes
Default By default, a process can be restarted a maximum of three times within one hour.
On the exception that exceeds this limit, the system reloads or fails over.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version
8.3.12.0
Version 8.4.1.0
694
— displays the system patches loaded with the in-service modular
Configure a process to be restartable.
Enter the number of times a process can restart within the
configured period. The range is from 1 to 3. The default is 3.
Enter the amount of time within which the process can
restart count times. The range is from 1 to 60 minutes. The
default is 60 minutes.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series.
High Availability (HA)