Dell S4810 Reference Manual page 1265

Parameters
sequence-
number
permit
redirect
ip-address
ip-protocol-
number
protocol-type
source
mask
any
host ip-address
destination
bit
operator
Policy-based Routing (PBR)
Enter a number from 1 to 65535.
Enter the keyword permit assign the sequence to the
permit list.
Enter the keyword redirect to assign the sequence to the
redirect list.
Enter the IP address of the forwarding router.
Enter the keyword ip-protocol-number then the number
from 0 to 255 for the protocol identified in the IP protocol
header.
Enter one of the following keywords as the protocol type:
• icmp for internet control message protocol
• ip for any internet protocol
• tcp for transmission control protocol
• udp for user datagram protocol
Enter the IP address of the network or host from which the
packets were sent.
Enter a network mask in /prefix format (/x).
Enter the keyword any to specify that all traffic is subject to
the filter.
Enter the keyword host then the IP address to specify a host
IP address.
Enter the IP address of the network or host to which the
packets are sent.
(OPTIONAL) For the TCP protocol type only, enter one or a
combination of the following TCP flags:
• ack = acknowledgement
• fin = finish (no more data from the user)
• psh = push function
• rst = reset the connection
• syn = synchronize sequence number
• urg = urgent field
(OPTIONAL) For the TCP and UDP parameters only. Enter
one of the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt= less than
1265