Output-Delay - Dell S4810 Reference Manual

Version 7.8.1.0
Version 7.6.1.0
pre-Version
6.2.1.1
Usage When the offset metric is applied to an interface, that value takes precedence over
Information an offset value that is not extended to an interface.
Related ip prefix-list
Commands

output-delay

Set the interpacket delay of successive packets to the same neighbor.
S4810
Syntax
output-delay delay
To return to the switch software defaults for interpacket delay, use the no
output-delay command.
Parameters
delay
Defaults Not configured.
Command ROUTER RIP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
pre-Version
6.2.1.1
1396
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— enters PREFIX-LIST mode and configure a prefix list.
Specify a number of milliseconds as the delay interval. The
range is from 8 to 50.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Routing Information Protocol (RIP)