Show Cam Mac Linecard (Dynamic Or Static) - Dell S4810 Reference Manual

vlan vlan-id
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.5.1.0
Version 8.3.7.0
pre-Version
6.2.1.1

show cam mac linecard (dynamic or static)

Display the CAM size and the portions allocated for MAC addresses and for MAC ACLs.
S4810
Syntax
show cam mac linecard slot port-set port-pipe [address mac_addr
| dynamic | interface interface | static | vlan vlan-id]
Parameters
linecard slot
port-set port-
pipe
address mac-
addr
dynamic
interface
interface
Layer 2
(OPTIONAL) Enter the keyword vlan then the VLAN ID to
display the MAC address assigned to the VLAN. The range is
from 1 to 4094.
EXEC
EXEC Privilege
Introduced on the S4820T.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the E-Series.
(REQUIRED) Enter the keyword linecard then a slot
number to select the linecard for which to gather
information.
(REQUIRED) Enter the keywords port-set then a Port-Pipe
number to select the Port-Pipe for which to gather
information. The range is from 0 or 1.
(OPTIONAL) Enter the keyword address then a MAC
address in the nn:nn:nn:nn:nn:nn format to display
information on that MAC address.
(OPTIONAL) Enter the keyword dynamic to display only
those MAC addresses the switch dynamically learns.
(OPTIONAL) Enter the keyword interface then the
interface type, slot and port information:
• For a Port Channel interface, enter the keywords port-
channel then a number.
• For a SONET interface, enter the keyword sonet then the
slot/ port information.
1039