Show Range - Dell S4810 Reference Manual

SFP 1 Tx Bias High Alarm Flag
SFP 1 Tx Power High Alarm Flag
SFP 1 Rx Power High Alarm Flag
SFP 1 Temperature Low Alarm Flag
SFP 1 Voltage Low Alarm Flag
SFP 1 Tx Bias Low Alarm Flag
SFP 1 Tx Power Low Alarm Flag
SFP 1 Rx Power Low Alarm Flag
===================================
!-------output truncated -------------------------!
Related
interface
Commands
show ip interface
show interfaces
interface.
show inventory (S-Series and Z-Series)
(including media), Dell Networking OS version including hardware identification
numbers and configured protocols.

show range

Display all interfaces configured using the interface range command.
S4810
Syntax
show range
Command INTERFACE RANGE (config-if-range)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.1.1.0
Interfaces
— configures a physical interface on the switch.
— displays Layer 3 information about the interfaces.
— displays information on a specific physical interface or virtual
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4093 VLANs on E-Series ExaScale.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced.
= False
= False
= False
= False
= False
= False
= False
= True
— displays the switch type, components
789