Vlan Max-Age - Dell S4810 Reference Manual

Parameters
vlan vlan-range
hello-time
seconds
Defaults 2 seconds
Command CONFIGURATION (conf-pvst)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.2.1.1
Related
vlan bridge-priority
Commands
vlan forward-delay
transitions to the forwarding state.

vlan max-age

show spanning-tree pvst
vlan max-age
To maintain configuration information before refreshing that information, set the time interval for the
PVST+ bridge.
S4810
Syntax
vlan vlan-range max-age seconds
To return to the default, use the no vlan max-age command.
Per-VLAN Spanning Tree Plus (PVST+)
Enter the keyword vlan then the VLAN numbers. The range
is from 1 to 4094.
Enter the keywords hello-time then the time interval, in
seconds, between transmission of BPDUs. The range is from
1 to 10 seconds. The default is 2 seconds.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced.
— sets the bridge-priority value.
— changes the time interval before Dell Networking OS
— changes the time interval before PVST+ refreshes.
— displays the PVST+ configuration.
1325